vBulletin stats
  Loading... Please wait...

SUUNTO PRODUCT RECALL - High Pressure Rubber Hoses Batch 1812


SUUNTO PRODUCT RECALL - High Pressure Rubber Hoses Batch 1812


Suunto announces a limited quantity safety recall

Dear Suunto Customer,

On 22nd August, 2013 Suunto Oy issued an important safety notice regarding high pressure rubber hoses. A limited batch of the high pressure rubber hoses used with Suunto air integrated dive computers, dive computer combos and analog combos has unfortunately been identified to have defective hose material which may impact the durability of the hose.


This defect may cause the high pressure rubber hose to leak or rupture leading to loss of breathing gas at higher than anticipated rate which may result in severe injury or death.


Diver safety is of highest importance to Suunto. Suunto announces a limited quantity safety recall of high pressure rubber hoses as identified below.

Identification of the affected high pressure rubber hoses:

  • Black rubber outer covering on hose
  • Marked with text 5000 PSIG PRESSURE TESTED - MADE IN USA
  • Hose diameter approximately 12,5 mm (1/2 inch) and length approximately 84 cm (33 inch)
  • Manufacturing batch code 1812 only

This recall applies only to the specific 1812 batch of the high pressure rubber hoses. Other high pressure rubber hoses are not impacted and need not be replaced.


The following products using this high pressure rubber hose may be affected: Cobra, Cobra 3, SM-36 pressure gauge and gauge combos, as well as Vyper and Zoop when purchased as combo products. A complete list of product codes can be found at the end of this document, and at http://www.suunto.com/recall.

To date, there have been no known injuries related to this issue. It is, however, mandatory that all affected products are returned for a hose change.


BARE Sports Canada keeps a record of all end users that have purchased Suunto products through our warranty database. We will be sending out an email to all end users that may be affected by this recall instructing them to do the following:
  • Investigate the product immediately.
  • If the hose has the above mentioned code 1812 printed on the hose, use of the product is prohibited until the hose has been replaced.
  • Return the entire unit with the defective hose attached to your nearest Suunto Authorized Dealer or Suunto Authorized Service Center for a hose change at no cost.

Recent Updates


Connect with us: Facebook Twitter YouTube